Wireless outdoor bridge, AP, Access Point, CPE, Base Station Total Solution Provider
Wireless Backhaul, Long range, High capacity, Point-to-Point (PtP) / Point-to-Multipoint (PtMP), Wimax, Wifi, Wireless Outdoor Bridge, AP, CPE, Base station, Taiwan, China, Manufacturers WLO-12410N

IEEE802.11n 2.4GHz 2T2R 300Mbps MIMO Wireless Outdoor Bridge / Wireless Backhaul, (800mW, 10dBi Directional Antenna Integrated, 2 x Ethernet)

PheeNet WLO-12410N is an IEEE802.11bgn 2.4GHz 2T2R 300Mbps MIMO Wireless Outdoor Bridge / AP, which has 10dBi Sector Antenna integrated and 2 LAN Ports (1 for LAN POE In, and another for LAN POE Pass-Through to another POE device). With WLO-12410N’s LAN POE Pass-Through port, 1 POE source can power on both WLO-12410N and another POE device, like POE IP Camera or POE AP, etc. 

WLO-12410N supports rich operation modes, like Router AP, WDS, AP, CPE + Universal Repeater, and Client Bridge + Universal Repeater. You can use WLO-12410N as a standalone AP to service 2.4GHz Wifi users; WDS mode to build up Point-to-Point or Point-to-Multiple-Point Bridge; Router AP mode to use WLO-12410N as a Router and Wifi AP. Because of rich operation mode support, it provides the installer more flexible deployments depends on demands. 

If you use WLO-12410N as a Wireless Hotspot Outdoor AP, you also can add PheeNet Network Access Control Gateway WMS-308N to have WLO-12410N AP management, and smart Wifi user management. 

Equips with robust Die Cast Housing and IP68 rated waterproof, WLO-12410N extremely satisfy WISP, Telecom Operator, System Integrator, Hotspot, SMB/Enterprise demands on any kind of Outdoor Wireless applications.










General Features
■ IEEE 802.11n draft 2.0 compliance in 2Tx/2Rx design
■ Support IEEE 802.11b, g, n
■ Operates in the 2.4GHz ISM band
■ Enables bandwidth of up to 300Mbps(Tx) , 300Mbps (Rx) link rate
■ Over load current protection
■ Wide Range Voltage support (12-68VDC)
■ Integrated Power over Ethernet (PoE)

Wireless Features
■ Number of ESSID (Virtual AP) : 7
■ Number of associated clients per AP : 32
■ Setting for max number associated clients
■ Number of Max. WDS Setting : 4
■ Setting for transmission speed, Dynamic Wireless Re-transmission
■ Channel Selection: Manual or Auto
■ Transmission Power Control : 1~100%
■ IEEE802.11h – TPC and DFS
■ IEEE802.11d – Multi country roaming
■ Channel Bandwidth Setting : 20MHz or 20/40MHz
■ Wireless Site Survey
■ IEEE802.11f IAPP : to facilitable faster roaming for the stations among different
APs nearby
■ IEEE 802.11i Preauth (PMKSA Cache )
■ HT Tx/Rx Stream selection : 1 or 2
■ A-MSDU and A-MPDU support
■ Maximal MPDU density for TX aggregation setting
■ Short Slot support
■ RTS Threshold and Fragment Threshold support

Networking
■ Support Static IP, Dynamic IP(DHCP Client) and PPPoE on WAN Connection
■ Support VPN Pass Through ( PPTP , IPSec , L2TP )
■ PPPoE Reconnect : Always on, On demand, Manual
■ MAC Cloning
■ DHCP Server (for CPE mode and Client Bridge mode)
■ 802.3 Bridging
■ Masquerading (NAT) (for CPE Mode)
■ Proxy DNS
■ Dynamic DNS
■ NTP Client
■ Virtual DMZ
■ Virtual Server (Port Forwarding)
■ Support MAC Filter
■ Support IP Filter
■ Bandwidth traffic Shaping

Wireless Security
■ Layer 2 User Isolation
■ Layer 2 AP Isolation
■ Blocks client to client discovery within a specified VLAN
■ WEP 64/ 128 Bits
■ EAP-TLS + Dynamic WEP
■ EAP-TTLS + Dynamic WEP
■ PEAP/ MS-PEAP + Dynamic WEP
■ WPA (PSK +TKIP)
■ WPA (802.1x certification + TKIP)
■ 802.11i WPA2 (PSK + CCMP/ AES)
■ 802.11i WPA2 (802.1x certification + CCMP/ AES)
■ Setting for TKIP/ CCMP/ AES key’s refreshing period
■ Hidden ESSID support
■ Setting for “ Deny ANY “ connection request
■ MAC Address filtering (MAC ACL)
■ No. of registered RADIUS servers : 1
■ VLAN assignment on BSSID
■ Support WEP, AES and TKIP data encryption over WDS link

Quality of Service
■ Download and Upload traffic control
■ Packet classifications via DSCP (Differentiated Services Code Point)
■ Control Policy by IP/IP Ranges/ MAC/ Service
■ Layer-7 Protocol Support
■ Traffic Analysis and Statistics
■ No. of Max. Policy setting : 10
■ DiffServ/ TOS
■ IEEE802.11p/ COS
■ IEEE 802.11Q Tag VLAN priority control
■ IEEE802.11e WMM

Management
■ Web-Based management & firmware upgrade
■ Reset to factory default
■ Profile Configuration Backup and Restore
■ Remote Link Test – Display connect statistics
■ Full Statistics and Status Reporting
■ NTP Time Synchronization
■ Event Log
■ Support SNMP v1, v2c, v3, MIBII
■ SNMP Traps to a list of IP address
■ CLI access via Telnet and SSH
■ Administrative Access: HTTP and HTTPS
■ UPnP (Universal Plug and Play)
■ Can be managed by WMS-308N, WSW-1808A




 Wireless

 Standard

IEEE 802.11b/g/n
IEEE 802.3u 100Base-TX Fast Ethernet

 Frequency Band

2.412 ~ 2.462GHz (USA)
2.412 ~ 2.484GHz (Japan) 
2.412 ~ 2.472 GHz (Europe ETSI)
2.457 ~ 2.462 GHz (Spain)
2.457 ~ 2.472 GHz (France)

 Channel Spacing

IEEE802.11b/g: 20MHz
IEEE802.11n: 20/40MHz

 Modulation

IEEE802.11b: DSSS (DBPK, DQPSK, CCK)
IEEE802.11g/n: OFDM (64QAM, 16QAM, QPSK, BPSK)

 Data Rate

IEEE802.11b: 1/2/5.5/11Mbps(auto sensing)
IEEE802.11g/n:
6/9/12/18/24/36/48/54/150/300Mbps

 Security

WEP (64/128Bit)
WPA / WPA2
Hidden ESSID User Isolation
AP Isolation
MAC Address Filter

 Receive Sensitivity

-97dBm

 Output Power

800mW

 Operating Mode

AP mode (AP +WDS)
WDS Mode (PTP, PTMP, Repeater)
CPE Mode (Router Client )
Universal Repeater + Client Bridge

 Hardware

 Processor

Atheros AR9341 – 400MHz MIPS CPU

 Flash

8MB

 SDRAM

32MB

 LED Indication

Power/LAN, Power/WAN ,Wireless

 Ethernet

- 10/100BASE-TX auto-negotiation
Ethernet port x 2 (RJ-45 connector)
- Power over Ethernet

 Antenna

10dBi Directional Antenna (H60, E60)

 Environment

Operating Temperature: -20 °C ~ 60 °C
Storage Temperature: -20 °C ~ 85 °C Humidity: 100%(non condensing)

 Power Supply

DC Input : 12V
POE : 48 VDC, 0.4A input (POE Injector)

 Power Consumption

9W

 Material

Aluminum Alloy Housing, W/ IP68 Rated Waterproof

 Dimensions

157 (L) x 96 (W) x 45 (H) mm

TOP